Here we will show how to read and write Fiat Magneti Marelli MultiJET MJD 6F3 Kline ECU by OBDSTAR DC706 ECU TCU programmer.
Device required
OBDSTAR DC706
P004 adapter
12V 5A power supply (essential)
MJD 6F3 Kline ECM
Go to ECM, quick search 6F3 and find Fiat Magneti Marelli MultiJET MJD 6F3 Kline MPC563+M58BW016DB+ 95320 ECU
Check instructions and wiring diagram
Connect ECM with DC706 and 12V power supply following the wiring diagram
Press Start
Select Bench mode with P004 adapter
Turn on the igntion on P004
Connect ECU.
Back up all data. Read and save all these data step by step.
Read EXT eeprom
Read INT flash
Read EXT eeprom
Then write EXT eeprom. Upload ext eeprom we backed up, then write ext eeprom to ECM
Then write INT flash and write EXT eeprom
After we write all data. We can read pin code, reset ECU, IMMO ON, IMMO Off and mileage calibration (correction) using OBDSTAR DC706.
Read pin code successfully.
IMMO ON
IMMO OFF
Mileage correction. Enter the mileage you need to write.
You can also reset ECU.
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.